Tuya 5-channel WiFi LED controller | 12-24 VDC
The WT5 controller is an advanced LED ribbon controller with a universal design to handle 1-colour, 2-colour CCT, coloured RGB, RGB-CCT and RGBW ribbons. Dimming and brightening for each channel is possible, including colour/colour adjustment. The unit has 5 output channels that can be configured to operate a given lighting set. Control can be achieved via an RF remote control operating in the 2.4 GHz range and via the Tuya app on a smartphone. Controlling with the remote control requires its pairing and using the Tuya app requires the controller to be connected to a Wi-Fi network. The controller is connected to the output of the LED CV power supply and LED strips are attached to its output terminals. Multiple controllers can be controlled with a single remote and up to 10 remote controllers can be attached to a single controller.
TECHNICAL PARAMETERS:
- number of outputs: 5
- Input voltage: 12-24 VDC
- maximum load current: 5x 63A
- Maximum load power: 3x 72W at 12V / 3x 144W at 24V
- connection: screw connectors 0.5-2 mm2
- Compatible power supply type: CV (constant voltage)
- PWM frequency: 1000 Hz
- range: up to 30 m
- dimensions: 120x43x35 mm
- weight: 55g
- compliance with standards: EMC: EN 301489-1 V2.2.3 / ETSI EN 301 489-17 V3.2.4 / LVD: EN 62368-1:2020+A11:2020 / RED: ETSI EN 300328 V2.2.2
- CE certification
- working temperature: -30...+55ºC
- protections: reverse polarity / overheating / output short circuit / output overload
CHARACTERISTICS:
- connection to the LED CV power supply using a screw connector or DC Jack
- The Tuya app allows you to switch the tapes on and off, adjust colour, hue (CCT) and brightness, etc.
- The type of LED strip must be set by pressing the Match button before starting the smartphone app. The LED strip must be connected according to the drawings.
- For RGB+CCT or CCT tape, switching the power on and off causes the colour to change sequentially (warm, neutral and cold).
- A short press of the Match button 3 times will change the brightening/dimming time of the lighting on switch-off and switch-on in the range of 0.5-3 s.
- cooperation with single-zone or multi-zone radio remote control (2.4 GHz). - design protected against overheating, overload and short-circuit at the output
CONNECT CONTROLLER TO TUYA APPLICATION :
- set the controller in the mode to operate the corresponding LED strip
- quickly press the Match button twice to enter configuration mode, the LED will rapidly flash purple
- press and hold the Match key for 5 s enter AP configuration mode, the purple LED indicator will start flashing slowly.
- if the Tuya APP network connection is successful, the RUN LED will stop flashing purple and switch on the corresponding light type according to the set configuration: white: DIM, yellow: CCT, red: RGB, green: RGBW, blue: RGB+CCT).